The liquid silica gel injection molding machine has the function of slow mold calibration, which makes the mold calibration more accurate and safe. It is a new type of multi-functional mold, which is suitable for all kinds of double-layer or multi-layer mold. The liquid silicone injection molding machine can adjust the slow closing function to adapt to the molding conditions of different module types. Accurate positioning in and out of the mold, 100% safe positioning, no damage to the mold.
Manufacturer of liquid silicone injection molding machine
In addition to the main machine of the liquid silica gel injection molding machine, a special liquid silica gel feeding system is required for the production of liquid silica gel products. The function of the feeding system is to add the liquid silica gel AB into the machine in the proportion of 1:1, and then inject it into the mold through the gun barrel. The accuracy of feeding system for liquid silica gel vulcanization molding is usually a: B = 1:1:1. If this ratio is wrong, what effect does this accuracy have on the production of liquid silica gel products?
When using the liquid silica gel injection molding machine, if the ratio deviation of AB glue is too large, it will affect the curing speed of liquid silica gel products. The speed of liquid silica gel curing press is related to the amount of platinum catalyst in silica gel. If the amount of single component rubber (a or B can be added) added with platinum catalyst is too large, the curing speed of liquid silica gel will be accelerated, and the liquid silica gel products are prone to be short of glue and over vulcanization. On the contrary, the slow curing rate of liquid silica gel and immature vulcanization of liquid silica gel products will lead to insufficient production of liquid silica gel products.
In order to prevent accidents in the production process, it is necessary to check the liquid silica gel injection molding machine before using it. Check whether there is water or oil in the electrical control box. Do not turn on the power supply if it is damp. You should blow dry it before turning on the power. Before operating the liquid silicone injection molding machine, check whether the power supply voltage meets the standard. Check the emergency stop switch again, whether the front and rear safety doors are opened and closed normally, and whether the rotation direction of motor and oil pump is consistent. Before using the liquid silica gel injection molding machine, check whether the cooling pipes are unobstructed, and introduce the cooling water into the oil cooler and the cooling jacket at the end of the cylinder.
Use liquid silica gel injection molding machine in strict accordance with the specification to avoid industrial accidents or machine damage caused by human factors. In order to make the liquid silica gel injection molding machine inject qualified silica gel products and maintain a long service life. Liquid silica gel injection molding machine should be maintained after use.
The above is the function of liquid silicone injection molding machine and the use of instructions, hope to read can help you, if you want to learn more about the liquid silica gel injection molding machine related information, welcome to online consulting customer service or call the company service hotline (top right corner of the website) for consultation, we will wholeheartedly provide you with quality service!
